上海伽桀测控,高性价比测试及应用解决方案服务商

SRS

您的位置:首页 > 产品展示 > 通用测试仪表 > SRS

Distribution Amplifier FS730 & FS735 — CMOS logic distribution amplifiers

The FS730/3 Series Distribution Amplifiers are used to distribute CMOS level logic pulses. Each amplifier has one input and seven outputs, all on BNC connectors. All inputs and outputs are logic levels.

  • High input impedance with hysteresis

  • High current outputs

  • Fast transition times

  • Small insertion delay

  • Low channel-to-channel timing skew

FS730 & FS735 CMOS Distribution Amplifiers

The FS730/3 Series Distribution Amplifiers are used to distribute CMOS level logic pulses. Each amplifier has one input and seven outputs, all on BNC connectors. All inputs and outputs are logic levels.

The Schmitt trigger input has a switching threshold of +1.3 VDC with 0.35 V of hysteresis. The input impedance is 1 kΩ.

Small Reflection Artifacts

Each output has a 50 Ω source impedance with logic levels of 0 VDC and 5.0 VDC. The 50 Ω source impedance will reverse terminate reflected pulses when driving unterminated lines. High impedance loads will be driven to 5 V and 50 Ω loads will be driven to 2.5 VDC. All of the outputs are driven by separate drivers to provide high isolation. The outputs have fast transition times and very low overshoot. The polarity of each output may be configured with a jumper inside the unit: installing the polarity jumper inverts the corresponding output. As shipped, the outputs are non-inverting.

The unit has two indicator LEDs. The “power” LED indicates that the unit has ac power. The “signal” LED will flash for 100ms on each rising or falling edge seen at the input.

Configuration

The FS73x series of products can be configured as half-width, 1U, benchtop instruments (FS730) shown above, or in full-width, 1U, 19" rack-mount enclosures (FS735) shown below.

The FS730/3 model provides 7 output BNC connectors on the front panel, and can be rack mounted with an optional rack

The FS735/3/3 model provides 14 output BNC connectors on the rear panel, with status indicators on the front panel. Several types of distribution amplifiers are available as listed below. Different types may be combined within the FS735 chassis.

Option 1 - 10 MHz distribution amplifier
Option 2 - 5 MHz distribution amplifier
Option 3 - CMOS logic distribution amplifier
Option 4 - Broadband 50 Ω distribution amplifier
Option 5 - Broadband 75 Ω distribution amplifier

 

上一篇:Distribution Amplifier FS730 & FS735 — 5 MHz distribution amplifiers

下一篇:Distribution Amplifier FS730 & FS735 — Broadband 50 Ω distribution amplifiers

回到顶部